Handlebar Plug / TBW Handlebars on Cable Throttle, 1" Bars

The plug that lets any Throttle-By-Wire cut handlebar run on a cable throttle bike.

Most 1 inch bars are now cut with the Throttle-By-Wire keyholes whether you need them or not, because it lets one bar cover both control types. On a cable throttle bike those notches sit open and visible at the right bar end. This Drag Specialties plug fills them, so the bar reads the same from either side.

Features

• Plugs the electronic throttle control notches on Throttle-By-Wire handlebars
• Allows Throttle-By-Wire bars to be used on non-TBW bikes
• Evens out the right and left side of the handlebar
• Made in the U.S.A.

Fitment

• Any handlebar with a 1 inch grip area that is notched for Throttle-By-Wire, fitted to a cable throttle Harley-Davidson
• Includes bars with a 1-1/8 inch or 1-1/4 inch clamping area that taper to a 1 inch control area
• Not needed on a Throttle-By-Wire bike, where the notches are in use

Note: Bars that are not cut for Throttle-By-Wire do not need this. The Burly 1 inch Scrambler Bars, for example, are drilled for internal wiring but are not notched for TBW.

Common Questions

Do I need one of these? Only if your bike runs a cable throttle and your bar is cut for Throttle-By-Wire. Check the right bar end for the notch.

Does it change how the bar fits? No. It fills the throttle control notches and nothing else. Mounting, wiring and grip fitment are unchanged.

Will it fit a bar that is not Thrashin? Yes. What matters is the 1 inch grip area and the TBW notch, not the brand.

Works With

Thrashin Supply: 1" High Bend, 1" Mid Bend, 1" Low Bend, 1" Aggressive Mid Bend and the 1" Bagger Handlebars. Biltwell: Tracker, Tracker Mid and Tracker High. Slyfox: 1" Black, 1" Chrome and the 1-1/8" Mid Bend. ODI: V-Twin Moto 1", V-Twin Moto 1-1/8" and the Podium V-Twin Moto. Arlen Ness: Moto Handlebars 1". Trask: 1-1/4" V-Line. Burly Brand: Folsom and Dominator T Bars.